Michael Backman Ltd - Home
Sinhalese Palm Leaf Book and Polychrome Covers (Ola)
length: 39.5cm, width: 5.2cm, thickness: 2.4cm
This well-preserved fine Sinhalese ola manuscript comprises approximately 40 leaves and a pair of covers. Each page is of trimmed palm leaf with blackened
edges and nine fine lines of dense Sinhalese script on both sides. There are no images, as is usually the case with Sinhalese palm leaf manuscripts.
The wooden covers, with bevelled outer edges, are finely painted with lotus petal borders and floral and scrolling foliage designs in green, orange and yellow
Such manuscripts were typically prepared for libraries attached to Sri Lankan Buddhist monasteries. Many of these are now held in the Colombo Museum
Library in Sri Lanka which now holds around 5,000 palm leaf manuscripts.
Most Sri Lankan palm leaf manuscripts are written on the prepared leaves of the Talipot palm (Corypha umbraculifera). It is one of the largest palms to grow in
Sri Lanka and grows to a height of 15-35 metres. The trees take 40 to 100 years to reach maturity and before the tree dies, it shoots out from its top an
inflorescence that can be as long as 7 metres.
The material used for preparing the writing leaf is taken from young trees and from the unopened leaf buds of such trees. Each leaf bud grows to 3 to 7
metres long and can hold up to 100 leaflets.
The preparation of the writing leaf required much care. A young tree would be selected and when the leaf bud was about to burst open it was cut off and slit
open. The leaflets were then separated and removed one by one. The midribs of the leaflets were removed and the leaflets were them immersed in a vessel
filled with cold water.
The vessel was then placed over a slow fire until the water reached boiling point. Thereafter the heat was reduced and the leaflets were allowed to simmer for
several hours. The leaflets then were taken out and allowed to dry for three days in the sun. Thereafter the leaflets were exposed to the cooler night air for
three nights, allowing them to become supple.
The next stage of the preparation process involved each leaf blade being weighted and then pulled up and down over the smooth surface of a cylinder of
wood which was usually the smoothed trunk of an areca palm (the tall, thin palm that produces betel nut.)
The manuscript pages then were cut from the leaves. They were punched with one or two holes using a steel punch. The holes later were used in the filing of
the pages – a bamboo slither was passed through a hole in each page so that all the pages could be held together. Held together, the edges of the pages
were then singed with a hot iron and burnt to remove any irregularities so that each page would be of uniform length and width.
Writing on each page was done with a style that had a steel point which was sharpened from time to time on an oiled stone. The writing then had to be
blackened otherwise it was too faint. This was done with ink made from combining fine dust made from charcoal from leaves, commonly cotton plant leaves,
with an alluvial resin. The mixture was heated until a black resinous oil was produced. This was rubbed over the manuscript pages with a cloth so that the
whole page was covered with black. This was then rubbed away with sifted rice bran, leaving the black resin in the scratched depressions left on the page by
As mentioned, palm leaf books were not normally illustrated.
Once the pages were finished, two covers were produced for them. These were made to size. The edges almost always were bevelled and the inner and outer
surfaces usually were painted, usually with colourful designs. The covers were made from one of various types of local woods such as ebony, iron wood, val
sapu, gammalu, jak or milla.
The leaves of the book and the covers then were strung together with a cord, either a cotton cord or one made from the fibre of the niyanda leaf.
The example here is in very fine condition. There is a small chip to one outer corner of one cover but other than that there is no obvious loss or damage.
De Silva, W.A, Catalogue of Palm Leaf Manuscripts in the Library of the Colombo Museum, Volume 1, 1938.
Provenance: UK art market
Inventory no.: 3185
This Item is available - Ask about this item
Click here to see more antique items from Sri Lanka.
Click here to see more items that relate to manuscripts and writing.
|Talipot palms, Kandy, central Sri Lanka. Photographed February, 2011.
|The monastery of Potgul Magila Vihara, central Sri Lanka, which holds perhaps central Sri Lanka's most extensive collection of ola manuscripts.
Photographed February, 2011
|An eighteenth century cave wall painting at Degaldoruwa Temple, central Sri Lanka, which shows a Kandyan king reading from an ola manuscript.
Photographed February, 2011
This giant inscribed tablet at Polonnaruva in
central Sri Lanka, assumes the shape of a
large palm leaf manuscript. It was completed
during the reign of King Nissankamalla
(1187-1196AD). Photographed February,
|High priests reading from palm leaf books, circa 1900.